Vax U90-M7 Series Instruction Manual page 6

U90-M7 Series User Guide.qxd:UG
vax.co.uk
Carpet Height Adjustment
The cleaning of carpet and rugs takes place at the nozzle
(A). When it is necessary to raise and lower the nozzle for
various carpet pile heights, turn the nozzle control knob
(B) to the desired setting (Fig.4/6).
B
Fig.4/6
Settings
For maximum cleaning performance, the following carpet
height settings are recommended (Fig.4/7):
• Lowest setting for all types of carpet.
• Higher settings: for very deep pile carpet, where easier
pushing effort is desired, while maintaining good
cleaning performance.
NOTE: If the cleaner is difficult to push, turn knob to
the next higher setting.
WARNING: The brushbar must NOT be rotating
!
when cleaning hard floors. Switch the brushbar off
to prevent damage to lino, parquet and other hard flooring.
Brushbar Shut-off
The brushbar shuts off automatically for tool use, when
the cleaner is in the upright position. To manually shut
off the brushbar for cleaning hard floors, step on the
pedal (A). The indicator (B) will show red in the "brushbar
off" window. To turn the brush bar on, step on the pedal
again. The indicator will show red in the "brushbar on"
window. (Fig.4/8)
Fig.4/8
6
how to operate / accessories
16/9/09 15:37
HIGH LOW
A
Fig.4/7
B
A
Page 6
5. Accessories
Select proper tool (Fig.5/1)
A. 2-in-1 tool: use with brush for carved furniture, table
tops, books, lamps, lighting fixtures, venetian
blinds, skirting boards, shutters, and registers. Remove
brush (Fig.5/3) to clean upholstered furniture, mattresses,
clothing, and carpeted stairs.
B. TurboTool: may be used for upholstered furniture,
mattresses, clothing, automobile interiors, and carpeted
stairs.
C. Crevice tool: may be used in tight spaces, corners and
along edges in such places as upholstered furniture,
stairs and skirting boards.
D. Wands: are used to give extra length to your hose.
Use them with any of the above tools.
E. Hard floor brush: used to vacuum any kind of hard
floor (some models only).
A
C
Fig.5/1
Attach Wand and Tools
Attach tool or wand to the hose (A).
Attach tool to wand (B) by pushing it firmly onto the
wand.
Twist wand or tool slightly to tighten or loosen the
connection (Fig.5/2).
B
Fig.5/2
B
E
D
A