How To Operate - Vax U90-M7 Series Instruction Manual

U90-M7 Series User Guide.qxd:UG

4. How to operate

On/Off Switch
Plug cord into electrical outlet. To turn cleaner ON, push
ON/OFF switch once. To turn cleaner OFF, push switch
again (Fig.4/1).
Fig.4/1
Brushbar Switch
The cleaner is shipped with the brushbar in the OFF
position. To turn the brushbar ON, step on the pedal (A).
The indicator (B) will show red in the "brushbar on"
window (Fig.4/2).
WARNING: The brushbar must NOT be rotating
!
when cleaning hard floors. Switch the brushbar off
to prevent damage to lino, parquet and other hard
flooring.
NOTE: As a precaution, Vax recommends that you raise
the brushbar as well as switching it off for use on lino and
hard floorings.
B
Fig.4/2
Cord Rewind
Grasp the end of the plug and pull to release cord from
cord reel. After desired cord length is reached, the cord
will lock into position.
Pull cord all the way out each time cleaner is used to
avoid heating of cord (Fig.4/3).
16/9/09 15:37 Page 5
NOTE: To prevent cord from whipping, hold plug until
cord is rewound.
A
Fig.4/3
Transporting Cleaner
To move your cleaner from room to room, put handle
in upright position, tilt cleaner back on rear wheels and
push forward (Fig.4/4).
Fig.4/4
Handle Positions
The handle of your cleaner has three positions; upright
for storage and when using cleaning tools; operating
position for general operation on carpet and floors; low
A
for reaching under low furniture. Step on handle release
lever to lower handle (Fig.4/5).
Fig.4/5
Vax Careline 0844 412 8455
1
2
3
how to operate
5