Vax U90-M7 Series Instruction Manual page 10

U90-M7 Series User Guide.qxd:UG
vax.co.uk
Headlight
IMPORTANT: Disconnect cleaner from electrical
!
outlet.
Removing Headlight Lens
Press handle release pedal and place handle in low
position. Using a Phillips screwdriver, remove the screw as
shown and lift off lens (Fig.6/10).
Fig.6/10
Installing Headlight Bulb
Pull old bulb straight out of socket. Push new bulb straight
into socket until locked in place. Excessive force is not
required. (Fig.6/11). For replacement bulbs please call Vax
Care line .
Fig.6/11
Replacing Headlight Lens
Reposition lens and secure with the screw (Fig.6/12).
Fig.6/12
10
maintenance
16/9/09 15:37 Page 10
Belts
IMPORTANT: Disconnect cleaner from electrical
!
outlet.
WARNING: Brushbar can start suddenly. Unplug
!
cleaner before turning it over.
The belts are located under the bottom plate of the
cleaner and should be checked from time to time to be
sure they are in good condition.
Replacing Flat Belt
Replace belt if it is stretched, cut or broken. To check the
flat belt, refer to Fig.6/13.
Removing Bottom Plate
Place handle in low position and turn cleaner over so
bottom side is facing up. Remove the 6 screws as shown
with a Phillips screwdriver. Lift off bottom plate (Fig. 6/13).
Fig.6/13
Removing Belt
Remove used belt (A) from large pulley (B) and discard
(Fig.6/14).
A
Fig.6/14
Positioning Belt
With lettering on outside of belt, slide new belt over motor
shaft (A). Place other end of belt over large pulley (B) while
rolling the pulley in direction shown. Turn brushbar making
sure belt turns freely and is not pinched between brushbar
and agitator shield (Fig.6/15).
B