How To Assemble - Vax U90-M7 Series Instruction Manual

U90-M7 Series User Guide.qxd:UG
vax.co.uk

3. How to assemble

Attach Handle
Using a Phillips screwdriver, remove (2) screws from the
top of the upper housing assembly (Fig.3/1).
Fig.3/1
Insert handle section (A) into upper housing assembly.
Push down firmly until you hear a click (Fig.3/2).
A
Fig.3/2
Fasten (2) screws on either side of handle base (Fig.3/3).
Fig.3/3
4
how to assemble
16/9/09 15:37 Page 4
Position Tools
Place smaller diameter end of wand (A) into bottom of
holder. Snap wand into clip at top. Repeat with other
wand.
Crevice tool (B) fits into one of the extension wands.
Fit 2-in-1 tool (C) into storage area on side of cleaner as
shown (Fig.3/4).
Fig.3/4
Fit TurboTool (A) into recessed area on front of cleaner.
Pivot toward handle to snap in place (Fig.3/5).
Fig.3/5
B
C
A
A
to pre
floorin
NOTE
the br
hard f