Janome My Lock 744D Instruction Book page 6

Table of Contents

Advertisement

1. Always be aware of the up-and-down movement of the needle and do not turn your attention
away from the machine while it is running.
2. When leaving the sewing machine unattended, the main switch of the machine must be
switched off or the plug must be removed from the socket-outlet.
3. When servicing the sewing machine, or when removing covers or changing lamps, the machine
must be disconnected from the power supply by removing the plug from the socket-outlet.
4. Do not place anything on the foot control, otherwise the machine will start inadvertently, or the
control or motor may burn out.
5. The maximum permissible power for the sewing lamp bulb is 15 watts.
6. When using your sewing machine for the first time, place a piece of waste fabric under the
presser foot and run the machine without thread for a few minutes. Wipe away any oil which
may have appeared.
1. Toujours être conscient du mouvement vers le haut et le bas de l'aiguille et toujours surveiller la
machine lorsqu'elle est en marche.
2. Lorsque la machine est laissée sans surveillance, l'interrupteur principal de la machine doit être éteint
ou la fiche doit être retirée de la douille/prise.
3. Lors des réparations de la machine à coudre ou lors du retrait des couvercles ou du changement des
ampoules, la machine doit être débranchée de la source d'alimentation en retirant la fiche de la
douille/prise.
4. Ne rien placer sur la pédale de contrôle, sinon la machine démarrera par inadvertance ou la pédale
ou le moteur pourront s'endommager.
5. La puissance maximale permise pour l'ampoule de couture est de 15 watts.
6. Lors de l'emploi de la machine à coudre pour la première fois, placer un morceau de tissu de rebut
sous le pied presseur et faire fonctionner la machine sans fil pendant quelques minutes.
Essuyer tout excédent d'huile qui pourrait être présent.
1. Siempre esté atento al movimiento sube y baja de la aguja y no deje de ponerle atención a la
máquina mientras está funcionando.
2. Cuando no esté atendiendo a la máquina, debe desconectar el interruptor de la máquina, o
desenchufarla del tomacorriente.
3. Cuando esté dándole servicio a la máquina, o cuando retire las cubiertas o esté cambiando las
bombillas, debe desconectar la máquina de la energía eléctrica sacando el enchufe del
tomacorriente.
4. No coloque ningún objeto en el pedal de control, pues la máquina podría comenzar a funcionar
inadvertidamente, o el control o el motor podrán quemarse.
5. La intensidad máxima permitida de la bombilla de luz es 15 vatios.
6. Cuando use su máquina de coser por la primera vez, coloque un retazo de tela debajo del pie
prensatela y haga funcionar la máquina sin el hilo por unos minutos. Seque cualquier aceite que
pueda haber escurrido.
4
Do's and Don'ts
Recommandations et interdictions
Lo que debe y no debe hacer

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents