Advertisement
If an extension cable is required, make sure that its cross-section is sufficient for the power
consumption of the saw. The minimum cross section must be 1.5 mm².
Cables rolled on drums may only be used when unrolled.
Check the power cord. Do not use faulty or damaged connecting cables.
Do not use the cable to disconnect the plug from the outlet. Protect the cable from heat, oil,
and sharp edges.
Do not expose the machine to rain and do not use the machine in a damp or wet environment.
Always ensure good lighting.
Do not saw near flammable liquids or gases.
When working outdoors, non-slip footwear is recommended.
Wear a hair net for long hair.
Avoid unnatural posture.
The operator must be at least 18 years old. Trainees must be at least 16 years old. However,
they may only use the machine under supervision.
Children must be kept away from the device connected to the mains.
Keep the workplace free of wood waste or parts lying around.
Disorder in the work area can result in accidents.
Do not allow others, especially children, to touch the tool or the power cord. Always keep them
away from the work area.
Persons working on the machine must not be distracted.
Conversions as well as adjustment, measuring and cleaning work may only be carried out with
the engine switched off. – Pull out the mains plug first!
Before switching on, check that wrenches or adjustment tools have been removed.
When leaving the workplace, the motor must be switched off and the mains plug disconnec -
ted.
All protective and safety devices must be reinstalled immediately after repair or maintenance
has been completed.
The manufacturer's safety, working and maintenance instructions must be observed. The di-
mensions specified in the technical data must be observed.
The relevant accident prevention regulations and other generally recognised safety rules must
always be observed.
Please note the notebooks of the employers' liability insurance association.
The machine must be connected to a 230 V socket with earthing contact and a minimum fuse
rating of 10 A.
Do not overload the machine. Do not use machines that are too inefficient for heavy work.
Do not use the cable for purposes for which it is not intended.
Ensure a secure footing at all times and keep your balance at all times.
Check that the moving parts function correctly and are not jammed or that parts are damaged.
All parts must be properly assembled and meet all conditions to ensure proper and smooth
operation of the tool.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Item 61970
Page 7
02
2021-1
Advertisement
