Advertisement
Quick Links
Operation Manual
Dust Extractor
61970
Illustration similar, may vary depending on model
Read and follow the operating instructions and safety information before using for the first time.
Technical changes reserved!
Due to further developments, illustrations, functioning steps and technical data can differ insignific -
antly.
Updating the documentation
If you have suggestions for improvement or have found any irregularities, please contact us.
Advertisement
Summary of Contents for WilTec 61970
- Page 1 Operation Manual Dust Extractor 61970 Illustration similar, may vary depending on model Read and follow the operating instructions and safety information before using for the first time. Technical changes reserved! Due to further developments, illustrations, functioning steps and technical data can differ insignific - antly.
- Page 2 All rights reserved. The WilTec Wildanger Technik GmbH cannot be held accountable for any possible mistakes in this operating manual, nor in the diagrams and figures shown.
- Page 3 Please read the operation in - structions carefully and make sure you have understood its content. Keep these operation instructions safe. Images © by WilTec Wildanger Technik GmbH Item 61970 Page 3 http://www.WilTec.de http://www.aoyue.eu...
- Page 4 © by WilTec Wildanger Technik GmbH Item 61970 Page 4 http://www.WilTec.de http://www.aoyue.eu 2021-1 http://www.teichtip.de...
- Page 5 ◦ Danger due to defects in the machine. If one or more parts of the machine are defective, it is forbidden to use them. Defective parts must be replaced immediately. Only spare parts approved by the manufacturer may be used. Modifications to the machine are prohibited. © by WilTec Wildanger Technik GmbH Item 61970 Page 5 http://www.WilTec.de...
- Page 6 The machine is equipped with a safety switch to prevent it from being switched on again after a voltage drop. Before commissioning, check whether the voltage given on the nameplate of the device matches the mains voltage. © by WilTec Wildanger Technik GmbH Item 61970 Page 6 http://www.WilTec.de http://www.aoyue.eu 2021-1...
- Page 7 Check that the moving parts function correctly and are not jammed or that parts are damaged. All parts must be properly assembled and meet all conditions to ensure proper and smooth operation of the tool. © by WilTec Wildanger Technik GmbH Item 61970 Page 7 http://www.WilTec.de http://www.aoyue.eu...
- Page 8 Factors that can influence the immission level at the current workplace include the duration of the effects, the © by WilTec Wildanger Technik GmbH Item 61970 Page 8 http://www.WilTec.de...
- Page 9 Switching off 1. Switch off the woodworking machine. 2. Switch off the extraction system by pressing the red “0” button or by pressing the emergency stop button (17). © by WilTec Wildanger Technik GmbH Item 61970 Page 9 http://www.WilTec.de http://www.aoyue.eu 2021-1 http://www.teichtip.de...
- Page 10 Dust and dirt must be regularly removed from the machine. Cleaning is best done with a fine brush or cloth. Do not use corrosive agents to clean the plastic. © by WilTec Wildanger Technik GmbH Item 61970 Page 10 http://www.WilTec.de http://www.aoyue.eu 2021-1 http://www.teichtip.de...
- Page 11 All WilTec electric devices that fall under the WEEE regulations are labelled with the crossed-out wheeled waste bin logo. This logo indicates that this electric equipment must not be disposed with the domestic waste.