Assembling The Blower; Converting From Blower To Vacuum - Toro Ultra 350 Operator's Manual

Setup

1. Assembling the Blower

1. Install the blower tube.
2. Install the inlet cover to the blower housing.
Figure 3
3. Snap the inlet cover into place to secure it to the blower
housing.
Figure 4
Important: You must install the blower tube before
installing the inlet cover because the inlet cover hooks onto
the blower tube. The blower will not run unless the bottom
inlet cover is locked in place.
2. Converting from Blower to
Vacuum
1. Remove the inlet cover.
Figure 5
The impeller rotates for a few seconds after you turn
off the blower and can cut or injure fingers.
Do not remove the bottom inlet cover when the motor
is running or when the unit is plugged into a power
outlet.
2. Remove the blower tube.
3