Cushman LSV 800 Service & Parts Manual page 48

Electric powered vehicle
Hide thumbs Also See for LSV 800:
Table of Contents

Advertisement

ELECTRICAL SYSTEM
To Speedometer
Front of Vehicle
Failure to follow these instructions can result in SERIOUS INJURY or DEATH
IF VEHICLE IS INOPERABLE AND NEEDS TO BE MOVED:
Turn the ignition key to the 'N' position and 'chock' tires to prevent inadvertent movement.
Flip the RUN-TOW switch to the 'TOW' position and move vehicle to the desired location and
park it properly on level ground and chock tires immediately.
Turn the ignition key to the 'OFF' position, remove key and perform required service
procedures following all Safety Guidelines as outlined in your repair manual.
In Case of Total Power Loss and the 'Run-tow' Switch DOES NOT Release
the Brake to Move the Vehicle :
Remove this plastic cover by removing 3 plastic fasteners. See illustrations below.
See emergency brake release instruction under this panel.
Push center
To reuse fastener
To secure fastener
of fastener
push center stem
in place press
with vehicle
up then install
down on
key.
fastener
center stem
When center is
through
until flush
depressed
shield into
with head of
lift fastener to
hole.
fastener.
remove.
5
13
Failure to follow these instructions can result in SERIOUS INJURY or DEATH
THIS PROCEDURE SHOULD ONLY BE TO CLEAR VEHICLE FROM AN UNSAFE AREA AND BE PERFORMED
THIS PROCEDURE SHOULD ONLY BE TO CLEAR VEHICLE FROM AN UNSAFE AREA AND BE PERFORMED
ONLY BY QUALIFIED TRAINED PERSONNEL
ONLY BY QUALIFIED TRAINED PERSONNEL
In Case Of Total Power Loss And The 'Run-tow' Switch DOES NOT Release The Brake To Move The Vehicle:
In Case Of Total Power Loss And The 'Run-tow' Switch DOES NOT Release The Brake To Move The Vehicle:
Turn the ignition key to the 'OFF' position and 'chock' tires to prevent inadvertent movement.
Turn the ignition key to the 'OFF' position and 'chock' tires to prevent inadvertent movement.
Identify the 'Auxiliary Power' line (3) and remove the Weather Pack Seal (4) from the connector.
Identify the 'Auxiliary Power' line (3) and remove the Weather Pack Seal (4) from the connector.
Identify the 'Primary Power' line (1) connector and disconnect the line (2).
Identify the 'Primary Power' line (1) connector and disconnect the line (2).
Connect 'Auxiliary Power' line (3) to 'Primary Power' line (1) which will release the brake. THIS WILL
Connect 'Auxiliary Power' line (3) to 'Primary Power' line (1) which will release the brake. THIS WILL
CAUSE THE VEHICLE TO MOVE IMMEDIATELY IF NOT ON LEVEL GROUND.
CAUSE THE VEHICLE TO MOVE IMMEDIATELY IF NOT ON LEVEL GROUND.
Move vehicle to desired location and park it properly on level ground, chock tires, IMMEDIATELY
Move vehicle to desired location and park it properly on level ground, chock tires, IMMEDIATELY
DISCONNECT 'AUXILIARY POWER' AND RECONNECT 'PRIMARY POWER' (1, 2) FOR SAFETY
DISCONNECT 'AUXILIARY POWER' AND RECONNECT 'PRIMARY POWER' (1, 2) FOR SAFETY
AND TO AVOID BATTERY DRAIN.
AND TO AVOID BATTERY DRAIN.
Reconnect the Weather Pack Seal (4) to the Auxiliary Power line (3) and perform required service
Reconnect the Weather Pack Seal (4) to the Auxiliary Power line (3) and perform required service
procedures following all Safety guidelines as outlined in your repair manual.
procedures following all Safety guidelines as outlined in your repair manual.
Page E-5
Fast / Slow
Switch
Key Switch
Can Plug
TOWING - Always select 'TOW'
DO NOT alter or tamper with this unit. Unauthorized modifications can result in
DO NOT alter or tamper with this unit. Unauthorized modifications can result in
position before towing
SERIOUS INJURY or damage to the vehicle and will void the warranty.
SERIOUS INJURY or damage to the vehicle and will void the warranty.
To disable electrical system, turn key switch to 'OFF' and remove battery wires.
To disable electrical system, turn key switch to 'OFF' and remove battery wires.
STORAGE
ALWAYS turn key to 'OFF' before disconnecting or reconnecting
ALWAYS turn key to 'OFF' before disconnecting or reconnecting
battery wires. ELECTRICAL ARC or BATTERY EXPLOSION can
battery wires. ELECTRICAL ARC or BATTERY EXPLOSION can
occur if key is not in the 'OFF' position.
occur if key is not in the 'OFF' position.
WAIT 30 seconds after reconnecting batteries BEFORE turning key switch to
WAIT 30 seconds after reconnecting batteries BEFORE turning key switch to
'REVERSE', 'FORWARD' or 'NEUTRAL' positions.
'REVERSE', 'FORWARD' or 'NEUTRAL' positions.
612594
609987
16
4
6
609694
647699 Service Parts Manual
To Battery
21
ELECTRICAL HARNESS ASSEMBLY WITH SOLENOID,
1
includes items 2 - 14 (FOR VEHICLES MANUFACTURED
UNTIL 23 APRIL 2016)
CONTROLLER SPLASH SHIELD ASSEMBLY
2
includes items 3 - 6
7
MAIN HARNESS includes item 8
RUN TOW SWITCH REPLACEMENT KIT
8
includes items 9 - 11
ELECTRICAL HARNESS ASSEMBLY WITH SOLENOID,
24
includes items 2 - 13, 25
Front of Vehicle
3
20
Relay
Controller
Motor
12
17
11
9

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents