Oil Viscosity; Fueling Instructions - Club Car Turf 272 Maintenance And Service Manual

10
PERIODIC MAINTENANCE
15. Remove the dipstick and add engine oil into the dipstick port. Use a funnel or pour spout to direct the oil
into the dipstick port (Figure 10-9). With filter change, the engine requires 38 ounces (1.12 liters) of oil
per change. Refer to oil viscosity guidelines for selection of oil grade (Figure 10-10). Replace the dip-
stick.
16. Connect battery and spark plug wire(s). See Connecting The Battery on page 1-3.
• Turf 272/Carryall 272/XRT 1200:
16.1. Lower the cargo bed. See WARNING "For vehicles with cargo beds..." on page 1-2.
• Carryall 472/XRT 1200 SE:
16.2. Replace the rear bench seat.
17. With the Forward/Reverse handle in the NEUTRAL position, run engine for 3 minutes and check for
leaks. Observe both the drain plug and the oil filter from under the vehicle and watch for oil leaks. If filter
leaks, tighten additional 1/4 turn and retest. If oil drain plug leaks, re-torque and retest.
18. Remove the dip stick and check the engine oil as a final step. Replace the dip stick.

OIL VISCOSITY

Choose the viscosity according to the temperature as indicated by the oil viscosity chart (Figure 10-10).
SAE 5W-30
Figure 10-10 Oil Viscosity Chart
NOTE: Using multi-grade oils (5W-20, 10W-30, and 10W-40) will increase oil consumption. Check oil level
more frequently when using them.

FUELING INSTRUCTIONS

Read General Warning, Section 1, Page 1-1
ý
DANGER
• Turn the key switch to the OFF position before fueling.
• Do not pour fuel into the fuel tank when the engine is hot or while it is running.
DANGER CONTINUED ON NEXT PAGE...
Page 10-8 2006-2010 Turf/Carryall 272/472 and XRT 1200/1200 SE Maintenance and Service Manual
SAE 30
SAE 10W-30/ SAE 10W-40
Fueling Instructions