Changing The Password; Changing The Device Name; Configuring Automatic Firmware Update Settings; Configuring The Remote Access - oventrop Datalog CS-BS-1 Installation And Operating Instructions For The Specialised Installer

6.4

Changing the password

In order to change the password, proceed as follows:
Î In the main menu Device config, select the sub-menu Users.
The Change password tab opens.
Î Tick the Change password checkbox.
Î Enter the current password into the Current password input field.
The factory setting for the password is admin.
Î Enter the new password into the New password input field.
Î Enter the new password into the Repeat new password input field.
Î Click Save configuration.
The message Configuration saved successfully! appears.
6.5

Changing the device name

Note
Choose a descriptive device name to facilitate identifying the Datalog CS-
BS-1 in the network.
In order to change the device name, proceed as follows:
Î In the main menu Device Config, select the sub-menu General.
Î On the General Configuration tab, enter the device name in the Device
Name input field.
Permitted characters are: letters, numbers, underscores.
Special characters are not allowed.
Î In the Default Language dropdown menu, select the desired language.
Î Click Save configuration.
The message Configuration saved successfully! appears.
6.6 Configuring automatic firmware update settings
The firmware is the internal software of the Datalog CS-BS-1. Through firmware
updates, the software will be improved in the following ways:
• Extended functional range
• Enhanced operation
• Customisation of the web interface desktop
When automatic firmware updates are enabled (strongly recommended), the Data-
log CS-BS-1 will search for new firmware versions in regular intervals.
Note
Previous configurations are not affected by a firmware update.
6.7 Configuring the remote access
AttENtION! third-party access!
When the default remote access password is not changed, third
parties may gain unauthorised access to the controller connected.
Î Do change the remote access password, note it down
and keep it in a suitable place.
The remote access password is required whenever a controller connected to the
Datalog CS-BS-1 is to be accessed via the ServiceCenter software.
In order to change the remote access password, proceed as follows:
Î In the main menu Device Config, select the sub-menu Remote Access.
Î On the Access S-Bus over local network tab, tick the Change password
checkbox.
Î Enter the current password into the Current password input field.
The factory setting for the remote access password is sbus.
Î Enter the new password into the New password input field.
Î Enter the new password into the Repeat new password input field.
Î Click Save configuration.
The message Configuration saved successfully! appears.
27