Lan Connection; Indication And Operating Element; Operating Control Led; Reset Button - oventrop Datalog CS-BS-1 Installation And Operating Instructions For The Specialised Installer

3.4

LAN connection

The Datalog CS-BS-1 can be connected to a router by using a network cable
(CAT5e, RJ45).
Î Connect the network cable included to the network adapter of the router and
to the LAN connector of the Datalog CS-BS-1.
For the next step of commissioning, see chapter 6 Basic configuration on page 10.

The integrated LAN connector
The LAN connector supports transfer rates of up to 100 MBit per second.
4

Indication and operating element

The following elements are featured on / in the housing of the Datalog CS-BS-1:
1 operating control LED / reset button
2 LAN connector

is located on the right-hand side of the device.


4.1

Operating control LED



The operating control LED indicates the operating status of the Datalog CS-
BS-1 by issuing flashing signals and colours.
4.2

Reset button



The reset button is integrated in the operating control LED. By means of the
reset button, the configuration of the Datalog CS-BS-1 can be reset to the factory
settings.
LED flashing codes
Colour Permanent
Orange S-Bus signal available, no con-
nection to Oventrop Portal
Green S-Bus signal and connection
to Oventrop Portal available
Orange /
Green
LED off The device is booting.
No mains voltage available.
Flashing Fast flashing
No S-Bus signal available Reset is running
S-Bus signal and IP address
available, no connection to
Oventrop Portal
The device is
booting
23