BonsenKitchen MF8001 Operation Instructions Manual page 7

OPERATION OF YOUR MILK FROTHER
Warm and thick foam
1. Place the appliance on a flat surface.
2. Then open the lid, insert the frothing paddle onto the shaft on the bottom of jar.
3. Fill the jar with the desired amount of milk, and replace the lid.
NOTE: T
he max milk quantity permitted to add is 150ml(see Fig. 1), to
avoid milk overflowing after frothing.The min milk quantity permitted to
add is 75ml.
NOTE: P
lease use whole milk, frozen milk (7-9°C).
4. Connect the plug into a power outlet.
5. Press the FUNTION button once, the working indicator of "Warm and thick foam"
will blink. Then press the ON/OFF button once,the working indicator of "Warm
and thick foam" will turn to illuminate solidly, the appliance will start to work.
Once the temperature of milk has achieved the setting value, appliance will
stop working;
Note: D
uring operation, you can stop operating by pressing the ON/OFF
button once.
6. When the appliance has stopped operating, open the lid, pour out the warmed
and frothed milk to enjoy it.
Caution: M
inimum 3 minutes rest time must be maintained between two
continuous cycles, otherwise, the appliance will enter self-protection state
automatically after working for 5 cycles continuously, the working indicator
will flash and the switch button will not be activated, after about 5 minutes,
the appliance will enter standby state and you can continue operating the
appliance.
NOTE: P
lease clean the jar according to the section "CLEANING AND
MAINTENANCE" between two continuous cycles.
7. Always turn off the milk frother and disconnect the power supply when not use.
6