BonsenKitchen MF8001 Operation Instructions Manual page 10

Only frothing separately, without warming
1. Place the appliance on a flat surface.
2. Then open the lid, insert the frothing paddle onto the shaft on the bottom of jar.
3. Fill the jar with the desired amount of milk, and replace the lid.
NOTE: T
he max milk quantity permitted to add is 150ml(see Fig. 1), to
avoid milk overflowing after frothing.The min milk quantity permitted to
add is 75ml.
NOTE: P
lease use whole milk.
4. Connect the plug into a power outlet.
5. Press the FUNTION button four times, the working indicator of "Only frothing
separately, without warming"will blink. Then press the ON/OFF button once,the
working indicator of "Only frothing separately, without warming"will turn to
illuminate solidly, the frothing paddle will rotate for frothing milk separately,
but the heating element will not heat. And the appliance will automatically stop
rotating after operating.
Note: D
uring operation, you can stop operating by pressing the froth
button once.
6. When the appliance has stopped operating, open the lid, pour out the frothed
milk and enjoy it.
Caution: M
inimum 3 minutes rest time must be maintained between two
continuous cycles, otherwise, the appliance will enter self-protection state
automatically after working for 5 cycles continuously, the working indicator
will flash and the switch button will not be activated, after about 5 minutes,
the appliance will enter standby state and you can continue operating the
appliance.
NOTE: P
lease clean the jar according to the section "CLEANING AND
MAINTENANCE" between two continuous cycles.
7. Always turn off the milk frother and disconnect the power supply when not use.
9