Hisense DH16 Use & Care Manual page 17

Empty Bucket Light
When this light is on, the compressor and the fan
stop running, it indicates that you need to check:
■ If the bucket is full, empty and re-install
bucket.
■ If the bucket is not in position, remove the
bucket and re-install it. Make sure the
bucket fits all the way into the dehumidifier
and the bucket light is off, or the dehumidifier
will not run.
Fan Speed
1. Single Fan speed .
NOTE:
Once the relative humidity of the room hit the
desired setting, the compressor will stop and the
fan will keep running.
Desired Humidity-Mode
1. Humidity can be adjusted manually .
■ If the humidity level of the room is higher
than the desired humidity setting, the
compressor will turn on. If the humidity level
of the room is lower than the desired humidity
setting, the compressor will turn off and the fan
will keep running.
NOTE:
The de-icing function will turn off the compressor
if a low temperature condition occurs. When the
de-icer senses the correct operating temperature,
the compressor will cycle back on. Some freezing
is normal when dehumidifiers are used at low
temperatures.
Power
Press POWER to turn on or turn off the dehumidifier.
Humidity Level
1. Press the Plus or Minus button to set the
desired humidity level. Desired humidity in
the digital display will flash for 5 seconds
after operation.
2. Actual room humidity will be displayed after
5 seconds of flashing the desired humidity.
3. To set the dehumidifier for continuous
operation, press the Minus button until "CO"
flash for 5 seconds and then display. In
continuous mode, room humidity will
be displayed .
NOTE:
If continuous mode is selected, the
dehumidifier will operate continuously at its
maximum dehumidification settings if
attached to a hose to drain or until the bucket
is full.
4. When the dehumidifier is operating in
continuous mode, press the Plus button and
then unit will stop the continuous running
and goes back to manual mode.
Digital Display
The display shows relative humidity.
1. When the dehumidifier is running, the display
shows the relative humidity of the room.
NOTE:
The humidity displayed is only for reference.
For accurate humidity, please check a hygrometer.
2. "CO" will be displayed when the dehumidifier
is operating in continuous mode.
3. In continuous mode, room humidity will
be displayed.
Clean Filter
1. When the Clean Filter indicator light is on,
remove, clean and replace the air filter. See
"Cleaning the Air Filter".
2. Press the POWER button for 5 seconds after
cleaning and replacing the air filter to reset
the filter monitor.
NOTE:
When the light is on, it will remain on for 180 hours
or until you press POWER button for 5 seconds.
14
NOT
NOT