Table of Contents
Advertisement
Adjust the crossfader curve
Activate the "Shift" button and press down the "Song Selection" encoder (i.e. the
centre encoder), and the two buttons "A" & "B" should stay light. Then slide the
crossfader to your preferred cross point. This would be your "A" cross point and
"B" cross point will be mirror symmetric. The section between your cross points
"A" & "B" is the center value. Press down the encoder again to complete the
adjustment.
Tip:
In general, a gentle curve is more suitable for long mixes (larger distance
between A/B as diagram A shown) and a sharp curve is more suitable for
scratching (i.e. less distance between A/B as diagram B shown).
A
Note:
Even if you have activated the cross fader adjustment function accidentally
(i.e. buttons "A" & "B" have been lit), without actually moving the cross fader, its
previous set cross point will not be affected even though the fader now is located
at a different cross point.
5. Effect control knobs (FX3, Filter, Hi, Mid, Low & Gain)
These adjust the channel filter amount, gain, the high-frequency, mid-range, low-
frequency EQ settings of each deck at your software.
6. Cue Volume knob
Adjust the cue volume.
7. Cue Mix knob
Adjust the Cue Mix value.
8. Song selection encoder knob
Rotate this knob to scroll through the song list and press button "A" or "B" to set
the selected song to Deck A or B.
9. Loop control encoder knob
Rotate to adjust a set loop at Deck A or B.
Rotate encoder
Rotate encoder
("Shift" button activated)
8
B
(Centre)
Diagram A
Center
Adjust the size of the loop
Move the loop forward or backward.
AB
(Centre)
Diagram B
Advertisement
Table of Contents
