Electrode Setting; Burner Start-Up Cycle; Adjustments, To Avoid Flame - Detachment, At Burner Ignition - Riello G3D MC Installation, Use And Maintenance Instructions

8.4

Electrode setting

The position of the electrodes cannot be regulat-
ed. In case of failure, check that the measure-
ments as shown on the figure are respected.
WARNING
Before removing or assembling the nozzle, loosen the screw
A)(Fig. 18) and move the electrodes ahead.
8.5

Burner start-up cycle

Normal
Thermostat
Motor
Ignition transformer
Valve
Flame
Lock-out lamp
8.6

Adjustments, to avoid flame - Detachment, at burner ignition

This inconvenience can occur, when the temperature of the light
oil decreases below + 8 °C.
1) Correct positioning of the electrodes, (see Fig. 18).
2) Nozzle: atomizing cone
Choose empt ies or semi-empt ies cones.
For exemple: Delavan type A - E; Steinen type H; Danfoss
type H.
3) Pump - setting
The pump is factory set, at a pressure of 12 bar.
When the temperature of the light-oil decreases below + 8
°C, increase the pressure to 14 bar.
4) Combustion-head setting
Regulate the combustion-head one set-point further ahead
than indicated in the instructions.
Example: the instructions require to set the combustion-
head on set-point 2.
Instead, the setting is made on set-point 3.
5) Fan - Air damper adjustment
Adjust the damper, reducing the excess air until the Bachar-
ach number is not near 1.
(i.e. a combustion with the lowest possible excess-air).
20028407
Start-up, calibration and operation of the burner
~ 12s
4 ± 0.3 mm
D5230
Lock-out due to failure to light
~ 12s
20 GB
A
2 - 2.5 mm
~ 5s
Fig. 18
D5229
Fig. 19