Controls And Leds - Creative Extigy User Manual

Controls and LEDs

Set the gain of the Mic In jack
to the minimum before
connecting a microphone,
especially if you are using
headphones.
The front panel of your Sound Blaster Extigy has these controls and LEDs:
Microphone Gain Control Knob
To control the microphone gain,
turn clockwise or counterclockwise.
Figure 1-3: Controls and LEDs on Sound Blaster Extigy.
CMSS LED
Lights up when CMSS mode*
is selected.
Dolby Digital LED
Lights up when a Dolby
Digital signal is detected.
CMSS Button
Press this button to turn the
CMSS mode* on or off.
Master Volume Control
Knob
To control the master volume
output, turn clockwise or
counterclockwise. This knob
turns freely and does not
have an end point.
Remote LED
Blinks when a signal from the
remote control is detected.
Power LED
Lights up green when Sound
Blaster Extigy is turned on.
IR Receiver
Receives signals from the
remote control.
Power Button
Press this button to turn Sound
Blaster Extigy on or off.
* CMSS mode enables
upmixing of mono or stereo
sources to 4 or 5.1 speaker
output.
About Sound Blaster Extigy 1-3