Using the Attachments
•
Read the Operator's Manual supplied with the
attachment before operating.
•
Ensure that the hydraulic quick couplers are free
of any contaminates before connecting.
•
Keep output shaft oiled to prevent rust.
•
Never operate the PTO with attachment in the
raised position. You will hear noise from the PTO
drive line if the attachment is raised.
Install the attachment as follows:
1.
Remove any attachment from the machine.
2.
Drive the machine into position behind the
attachment mount adapter. Raise the mount
adapter of the machine into the attachment
adapter.
3.
Secure the mount adapters together with the
attachment pin and hairpin as shown in
99.
Figure 99
1. Attachment pin
2. Hairpin
Figure
g004972
3. Machine mount adapter
4. Attachment mount adapter
Routing the Snowthrower
Wires
Route the snow thrower wires from the cab, through
the eyelet and to the snowthrower.
1. Wire eyelet
Removing the Winter Frame
Note:
Retain or loosely install the hardware that you
removed during this procedure so that it is available
for seasonal changeover.
Preparing the Machine for
Seasonal Changeover
1.
Start the machine and remove any attachments.
Note:
Position the machine so that you can
roll away the winter frame, you can install the
summer frame, and you can raise the rear of the
machine with a floor jack. Store the attachment
as instructed in the manufacturers Operator's
Manual.
2.
Lower the lift arm A-frame.
3.
Disconnect the battery cable connected to the
negative (-) battery terminal.
44
Figure 100
g032850