Toro Polar Trac Cab 30474 Operator's Manual page 28

2. Disconnect the pivot arm and pivot bracket by
removing the hairpin securing the pivot pin and
washer (Figure 50).
Figure 50
1. Washer
2. Pivot pin
Note:
Retain or loosely install the hardware
that you removed during this procedure so that it
is available for seasonal changeover.
3. Remove the 2 hairpin from the pivot pins that
connect the operator platform to the pivot
bracket (Figure 51).
Figure 51
1. Hairpin
4. Have an assistant help you remove the pivot
pins and the operator platform
Note:
Set the deck aside for seasonal
conversion.
5. Install each of the pivot pins you removed earlier
through the seat platform and pivot bracket, and
secure it with the hairpins.
g032774
3. Lift arm
4. Hairpin
g032443
2. Pivot pin
(Figure 51).
Disconnecting the PTO
1. Loosen the PTO drive-shaft bolts and nuts.
2. Remove the roll pin and pull the drive shaft off
the gearbox shaft
1. Drive shaft
2. Gearbox
Note:
Retain or loosely install the hardware
that you removed during this procedure so that it
is available for seasonal changeover.
Disconnecting the Summer Frame
1. Remove the bolts and 2 cover plates to access
the nuts and bolts that secure the summer frame
to the machine
1. Bolts
28
(Figure 52).
Figure 52
3. Bolts
4. End yolk
(Figure 53).
Figure 53
2. Cover plate
g004928
g032736