General Problems With The Tumble Dryer - Miele 11 892 110 Operating Instructions Manual

Problem solving guide

General problems with the tumble dryer

Problem
You can hear buzzing or
humming operating
noises.
A programme does not
start
When the DryFresh,
PowerFresh or Dry-
Care 40 extra options
are selected, the drying
level "jumps back" to a
different one.
The display is dark and
the Start/Add laundry
sensor control is flash-
ing slowly.
The dryer is switched
off at the end of the
programme.
The display is in a dif-
ferent language.
68
Cause and remedy
The compressor (heat pump) is operating. Or you
have selected a programme which sprays con-
densed water into the drum.
 No action required. These noises are quite nor-
mal and can be heard when the compressor or
the condensed water pump is operating.
There is no fault.
No obvious cause.
 Connect the tumble dryer to the mains
 Turn on the tumble dryer
 Close the door
 Check whether the mains fuse has tripped
Has there been a power cut? When power is re-
stored any previously running programme will re-
start automatically.
The drying level you selected previously cannot be
combined with the extra option. The closest pos-
sible drying level is selected automatically.
The display has switched off automatically to save
energy (Standby mode).
The drum will turn at intervals when the tumble dryer
is in the anti-crease phase.
 Press any control. This switches Standby off.
The tumble dryer switches off automatically. This is
not a fault, but a normal function.
A different language has been selected in "Settings,
Language ".
 Set the language you want. The flag symbol serves
as a guide.