Table of Contents
Advertisement
Problem solving guide
Message
Clean the plinth filter.
See
Empty container.
See
Blockage detected.
See
Service Fault F
XXX
64
Cause and remedy
The plinth filter looks clean after thorough cleaning.
However, the programme terminates and the fault
message appears again. It is likely that there is still
underlying residue that could not be removed.
To clear the message, turn the programme selector
to the position.
Check for the possible causes described below.
The heat exchanger is clogged.
Check the heat exchanger. Follow the instructions
in "Problem solving guide – Checking the heat ex-
changer".
The plinth filter is clogged further down.
Check the plinth filter. Follow the instructions de-
scribed in "Problem solving guide – Replacing the
plinth filter".
If the plinth filter is not out of shape or damaged,
you can reactivate it in a washing machine. Follow
the instructions described in "Problem solving
guide – Reactivating the plinth filter".
The condensed water container is full or there is kink
in the drain hose.
To clear the message, open and close the door
with the tumble dryer switched on. Or switch the
tumble dryer off and then on again.
Empty the condensed water container.
Check the drain hose.
The laundry is unevenly distributed or has rolled up.
Open the door and loosen the laundry. If neces-
sary, take out some of the laundry.
Switch the tumble dryer off and then on again.
Start a programme.
There is no obvious cause.
Switch the tumble dryer off and then on again.
Start a programme.
If the programme is cancelled again with the same
fault message, then there is a fault. Contact the Miele
Customer Service Department.
Advertisement
Chapters
Table of Contents
