Craftsman CMEW020 Instruction Manual page 8

English
Fig. F
3
19
3. Insert a M6 x 1 mm x 16 mm button head screw
through fence tilting bracket
square nut 17 onto threaded end of screw
COM PLETE LY TIGHTEN SCREW AT THIS TIME. Assemble
screw and square nut to opposite end of tilting bracket
in the same manner.
Fig. G
4. Slide groove of fence
18
Fig. H
5. Position fence so that rounded section
1
bottom of fence is over cutterhead opening.
6
13
16
15 and thread a M6 x 1
16 . DO NOT
15
16
17
over square nuts .
17
18
17
on
45
Fig. I
6. Tighten two screws 16 using included hex wrench.
Fig. J
Cutterhead Lock (Fig. K)
Assemble cutterhead lock
4
base, using the M6 x 1 mm x 12 mm button head screw
nOTE: The cutterhead lock is to be engaged with the
cutterhead shaft only when setting knives. All other
times, the cutterhead lock should be disengaged from
the cutterhead.
Fig. K
4
21
45
16
to the front side of the jointer
21 .