Profi-pumpe AC23A Operating Instructions Manual page 3

4. OPERATION
The installation must be performed by a qualified professional.
Please, check each time before using, the electrical connections and the cables are not damaged. Check
before the installation whether the electrical connections are earthed according to the statutory regulations
and are installed.
Also, it is NOT recommended to perform, for example, a cable extension. It is not certain whether this modifi-
cation is technically correct, so this warranty is void.
5. SECURITY TIPS
l Obey absolutely valid regulations on the electrical security
l To avoid shocks and fire risks, read and follow closely the following instructions:
• Always unplug the device from the mains before carrying out any work on it.
• Be sure that the electric line connecting the device to the mains and the extension leads have a cross-sec-
tion suitable for pump power and be sure that the electrical connections are far away from any water source
• When Flow guard is used for swimming pools, ponds and fountains if is necessary to use an automatic RCD
with IDn = 3OmA protection.
Warning: when the pump stops the pipes are under pressure consequently we recommend opening a tap to
discharge the system before carrying out any work.
• Installation only in frost-proof areas without condensation. Thus not in cisterns, wells, shafts, other damp or
frost-prone rooms and containers.
l The electrical connections are always to be carried out by an authorised professional
l Operation can not be performed by children and young people under 16 and people with intellectual disabilities
THE MANUFACTURER EXPLAINS:
l To take over no responsibility in the case of accidents or damages on the basis of carelessness or disregard to the
instructions in this book.
l To reject every responsibility for the damages which originate from the improper use of the device.
6. SERVICING
It may happen occasionally that dirt is retained in the internal check valve and this is no longer seals 100%. The first re-
medy should be always trying to flush the check valve free. For this purpose, eg. As the Garden side faucet on full blast,
so that the pump at full rated power promotes about 30 minutes water. Is then the timing is not clear, the unit must be
replaced. Prior to installation of the new device, the pump is in, free to flush any case, as previously described. Opening
the device on non-return valve is prohibited and always results in the loss of any existing warranty. In addition, persons
could be dangerous when Operating a clocking pump occur, so that the pump may be operated under any circum-
stances continue. Until the device replacement, the pump must be taken out of service. For abrasive materials such as
sand, shortening the Maintenance period and the device lifetime.
The following checks should be carried out regularly:
l functional test (min. every 3 months)
l integrity of the power cord
l Clean the guide lines (eg no buckling)
l Clean the media (no sand, no sludge)
7. GUARANTEE REGULATIONS
For all manufacturing and material defects, the statutory warranty applies. In these cases, we assume the
Exchange or appliance repairs. Shipping costs are borne by us only to the extent legally
is prescribed.
In case of warranty please call our service platform http://www.profi-pumpe.de/service.php log the event.
Then we will inform you how to proceed with case by case basis.
Returns please sufficient postage. Unfortunately prepaid returns will not be accepted,
because they are filtered out before delivery. Our service we provide in Germany.
The warranty does not cover:
l Improper installation (proper installation, unauthorized persons)
l Material wear (eg. seals) or dirt in the unit
l Unjustified interventions or changes in the device
l Damages by selffault
l Improper servicing and improper use
Moreover, we give no damage compensation for secondary damages!
English 3