Reassembling The Pump - Dometic P030 Installation And Operation Manual

Maintenance
7 .6 Installing a Pump Wet End
Replacement Kit (Optional)
If any of the pump components besides the impeller
bushing require replacement, follow the instructions
below to install the pump wet end replacement
kit before reassembling the pump. This kit is sold
separately. It includes the pump head that attaches to
the motor.
1. For small pumps 2 hp (1.5 kW) or less, place the
pump in an upright position on the fan end of
the motor or securely clamp the pump feet to a
workbench. For larger pumps with 3 hp (2.2 kW) or
greater, place the pump and motor securely on the
floor with the pump head facing up.

7 .7 Reassembling the Pump

q
w r
9 P030 Reassembly
q
w
r
e
10 P045, P048, P075, P100 Reassembly
14
t
y
i
t
y
u
2. Remove the screws or bolts and lock-washers (if
present) securing the pump head to the motor
adapter/barrier. Use tools appropriate for the
fasteners installed.
3. Firmly hold the pump head (or the side that is not
clamped) and pull straight out to disengage the
pump head and motor.
4. Align the holes on the replacement pump wet end
assembly with the holes on the motor adapter.
5. Install the screws or bolts and lock washers (if
present).
I Refer to Figure 9, 10, or 11 on pages 14-15
(depending on the pump model) for a reassembly
diagram.
d
f
a
o
s
d
Magnetic-Drive Centrifugal Pump
h
g
h
f
g
EN