Feider Machines FBT420 Original Instructions Manual page 3

operating speed and protects the power source and all moving parts from damage caused by over-
speed. Seek authorised service if a problem exists;
12) Do not transport this machine while the power source is running;
13) Shut off the power source and disconnect the spark plug lead (electric unit disconnect from
supply) whenever you leave the work area;
14) Do not tilt the machine while the power source is running.
Mandedintenance and storage
a) When the machine is stopped for servicing, inspection, or storage, or to change an accessory,
shut off the power source, disconnect the spark plug wire from the spark plug, make sure that all
moving parts have come to a complete stop and, where a key is fitted remove the key. Allow the
machine to cool before making any inspections, adjustments, etc.
b) Store the machine where fuel vapour will not reach an open flame or spark. For extended storage
periods, run the unit dry of fuel. Always allow the machine to cool before storing;
c) When servicing the cutting means be aware that, even though the power source will not start due
to the interlock feature of the guard, the cutting means can still be moved by a manual starting
mechanism.
Additional safety instructions for units with bagging attachments
a) shut-off the power unit before attaching or removing the bag.
For Your Own Safety, Read Instruction Manual Before Operating this Machine
The purpose of safety symbols is to attract your attention to possible hazardous conditions. This
manual uses a series of symbols and signal words which are intended to convey the level of
importance of the safety messages. The progression of symbols is described below. Remember that
safety messages by themselves do not eliminate danger and are not a substitute for proper accident
prevention measures.
Indicates an imminently hazardous situation which, if not avoided, WILL result in death or serious
injury.
Indicates a potentially hazardous situation which, if not avoided, COULD result in death or serious
injury.
Indicates a potentially hazardous situation which, if not avoided, MAY result in minor or moderate
injury. It may also be used to alert against unsafe practices.
This symbol is used to alert the user to useful information about proper operation of the machine.
Safety Instructions for Machinery
1. READ THROUGH THE ENTIRE MANUAL BEFORE STARTING MACHINERY.
Machinery presents serious injury hazards to untrained users.
2. ALWAYS USE ANSI APPROVED SAFETY GLASSES WHEN OPERATING MACHINERY.
Everyday eyeglasses only have impact resistant lenses, they are NOT safety glasses.
3. ALWAYS WEAR AN ANSI APPROVED RESPIRATOR WHEN OPERATING MACHINERY THAT
PRODUCES DUST. Wood dust is a carcinogen and can cause cancer and severe respiratory
illnesses.
4. ALWAYS USE HEARING PROTECTION WHEN OPERATING MACHINERY.
Machinery noise can cause permanent hearing damage.
5. WEAR PROPER APPAREL. DO NOT wear loose clothing, gloves, neckties, rings, or jewelry
which may get caught in moving parts. Wear protective hair covering to contain long hair and wear
non-slip footwear.
6. NEVER OPERATE MACHINERY WHEN TIRED, OR UNDER THE INFLUENCE OF DRUGS OR
ALCOHOL. Be mentally alert at all times when running machinery.
7. ONLY ALLOW TRAINED AND PROPERLY SUPERVISED PERSONNEL TO OPERATE
MACHINERY. Make sure operation instructions are safe and clearly understood.
8. KEEP CHILDREN AND VISITORS AWAY. Keep all children and visitors a safe distance from the
work area.
9. MAKE WORKSHOP CHILD PROOF. Use padlocks, master switches, and remove start switch
keys.
10. NEVER LEAVE WHEN MACHINE IS RUNNING. Turn power OFF and allow all moving parts to
come to a complete stop before leaving machine unattended.
11. DO NOT USE IN DANGEROUS ENVIRONMENTS. DO NOT use machinery in damp, wet
locations, or where any flammable or noxious fumes may exist.
12. KEEP WORK AREA CLEAN AND WELL LIT. Clutter and dark shadows may cause accidents.
13. USE A GROUNDED EXTENSION CORD RATED FOR THE MACHINE AMPERAGE.
Undersized cords overheat and lose power. Replace extension cords if they become damaged. DO
3