Advertisement
Replacing the SATA PCI Controller Card
The cover is seated tightly on the chassis. Standing in front of the server, use the
2
heel of your hand to deliver a short, forceful thrust to the cover pad on the rear
cover plate of the server.
Slide the cover off and set it aside.
3
Removing the Card Cage Assembly
To disconnect the SATA ribbon cable, unlock the connector, unlock the cable
1
retainer (mechanism not shown), and then grasping the edges of the connector,
pull it out of its receptacle.
Connector
Receptacle
Position yourself on the left side of the server (side furthest from the AC/power
2
cord receptacle).
Pressing the latch at the front of the assembly with one hand while grasping the
3
assembly with the other, lift the assembly straight up in a strong, even motion.
When removing the card cage assembly, do not grasp it by the handle. The
Note
handle is not strong enough to remove the card cage assembly.
Set the assembly aside.
4
2
Copyright © 2009, Overland Storage, Inc. All rights reserved. Information in this document is subject to change without notice and does
not represent a commitment on the part of Overland Storage or any of its subsidiaries.
Latch
Snap Server 18000
Guides
Field Service Documentation
Advertisement
