Replacing the SATA PCI Controller Card
Replacing the internal controller PCI card may be performed by a single
administrator; no tools are necessary.
There are static-sensitive electronics inside the unit. Before you handle any
Caution
parts, make sure you are working at a static-controlled workstation and that you are
properly grounded.
Taking the Server Offline for Hardware Modifications
Power down the server before you make any repairs. Improper shutdown may lead to
loss of data or physical harm.
To start the shutdown process, press the power
1
button on the front of the server.
The green power LED remains lit until the shutdown
process is complete. DO NOT disconnect the AC
power cord while the LED remains lit.
After the power LED is off, disconnect the AC power
2
cord(s) and all other cables from the back of the
server.
The server is heavy. With the help of an assistant, remove the server from the
3
rack to a clean surface with ample room to the front and rear.
Removing the Rear Cover Plate
To release the rear cover plate, turn the locking screw at the rear of the server
1
counterclockwise until the screw pops loose.
Front Cover Plate
Field Service Documentation
Copyright © 2009, Overland Storage, Inc. All rights reserved. Information in this document is subject to change without notice and does
not represent a commitment on the part of Overland Storage or any of its subsidiaries.
Cover Pad
Rear Cover Plate
Snap Server 18000
1
2
3
4
5
6
7
8
Locking Screw
1