Cleaning And Storage - Silvercrest XJ-13409 Instructions Manual

Nutriton mixer
Hide thumbs Also See for XJ-13409:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 35
8. To switch it off, rotate the shaker (1, 9) as far as it will go anticlockwise.
9. Wait until the blades have come to a complete standstill. Then pull the mains plug out of
the plug socket and detach the shaker (1, 9).
10. Turn over the shaker (1, 9) and unscrew the blade attachment (3, 8).
11. You can serve the food you have prepared directly or select a lid as required (storage
lid, to-go lid or sprinkle lid (5, 6, 7)) and screw it onto the shaker (1, 9).
12. Clean the accessories immediately after each use to prevent germ formation (see the
"Cleaning and Storage" chapter). Do not allow any food residues to dry on.

Cleaning and Storage

CAUTION!
Danger of electric shock! Remove the mains plug from the plug socket before doing
any cleaning.
Danger of electric shock! Keep the motor unit, the mains cable and the plug away
from water or other liquids! Never touch them with wet hands.
The motor unit and the blade attachments are not suitable for being cleaned in the
dishwasher!
Danger of injury due to sharp blades! Be extremely careful when handling the
blade attachment. The blades are very sharp. Never touch the blades with bare hands.
Always hold the blade attachment by the plastic housing when you remove, insert or
clean it.
Surfaces could be damaged! Do not use any caustic or abrasive cleaning agents
or scouring sponges to clean the device.
Shakers and lids are suitable for cleaning in the dishwasher.
Clean the device and accessories immediately after each use to prevent germ formation:
1. Make sure that the device is disconnected from the mains power!
2. Rinse the accessories which have been used (blade attachment, shaker and lid) with
clear, warm water and some mild detergent. Shakers and lids can also be cleaned in
the dishwasher.
3. If necessary, wipe down the motor unit with a slightly damp cloth. Then dry it with a
soft cloth.
4. Allow all parts to dry completely before you put them back together.
5. Store the device in a dry, clean place that is not accessible to children and animals.
NOTE: The plastic parts may suffer discolouration over time. However, this does not have
any negative effect on either your health or the way that the device parts work.
41

Advertisement

Table of Contents
loading

This manual is also suitable for:

279914

Table of Contents