Table of Contents
Advertisement
PCBS AND MOTORS
6.8.3 PRINTER CONTROLLER / NIB
Printer Controller
1. Remove the controller cover [A] (6 screws).
2. Remove the network interface board [B] (2 screws).
3. Remove the printer controller board [C] (6 screws, 1 connector).
4. Remove the NVRAM from the controller board, then install them on the new
controller.
5. Install the new controller.
6. Turn on the machine and print the Printer Configuration Page.
7. Ensure that all the controller settings are restored.
NIB
1. Back up the NIB NVRAM to the controller using the Service Tool.
2. Remove the controller cover [A] (6 screws).
3. Replace the network interface board [B] (2 screws).
4. Turn on the machine and restore the NIB NVRAM using the Service Tool.
5. Turn off the machine and turn it back on. Then, print the Printer Configuration
Page.
6. Ensure the all the controller settings are restored.
[C]
[B]
[A]
G038R510.WMF
6-26
1 October, 1999
Advertisement
Table of Contents
