HPM XLP912WEWE Instruction Manual

1

Load Compatibility

Load Type
XLP912WEWE XLP913WEWE
Incandescent
240V Halogen
Low Voltage Halogen
with electronic
transformer
Low Voltage Halogen
with ferromagnetic
transformer
Linear Fluorescent
Compact Fluorescent
Fan Motor
Contactor 1 max (< 2A)
Note: Minimum load for XLP913WEWE is 40W.
2

Operation

XLP912WEWE and XLP913WEWE are Passive Infra-Red (PIR) movement sensors. When movement is
detected, the connected load will switch on for a time period that can be preset by the user.
XLP912WEWE is a 3-wire product and thus requires a neutral. It has a relay output which turns the load on
and off without dimming.
XLP913WEWE is a 2-wire product with a solid state output which turns the load on and off gradually over a few
seconds.
Both models have adjustments for the following:
1 Time delay (1 second to 16 minutes)
The period of time the load stays on after movement is detected.
2 Detection range (3 metres to 10 metres)
See range diagrams overleaf.
3 Brightness threshhold (3 lux to 1000 lux)
Sensor will only operate if ambient light is below this value. For day time operation use a higher lux setting,
and for night operation only use a lower lux setting.
These adjustments are located underneath the front cover.
Maximum Load
1000W 400W
1000W 400W
500VA 400VA
500VA 400VA
500VA Not Suitable
500VA Not Suitable
100VA Not Suitable
Not Suitable
10 m
3 m
16 °
1°
Excel Movement Sensor
Cat XLP912WEWE & XLP913WEWE
Instruction Manual
1000 lux 3 lux