Polaris P280 Instructions For Installation And Use Manual page 11

2.6.1 If the hose is too long = Cut the feed hose
• Don't cut the lead hose : it must stay the equal to the depth of the pool, see
the lead hose".
• Remove the quick disconnect from the sucti on port : simultaneously unscrew and pull. See picture
• Unscrew the swivel to separate the feed hose into two equal secti ons, see picture
• Cut the excess length, for example : 0.50 cm, by removing the same amount from each of these two secti ons, i.e.
0.25 cm on each secti on (in the example shown), see picture
• Assemble the two feed hose's secti ons using the swivel and att ach clamps, see picture
• Adjust the distance between each fl oat on the feed hose; the recommended distance between each fl oat is 45 to Adjust the distance between each fl oat on the feed hose; the recommended distance between each fl oat is
90 cm. Slide the fl oats on the hose to positi on them, see picture
Lead hose
connecti on
Feed hose (secti on 1)
(for exemple)
2.6.2 If the hose is too short = add a secti on of feed hose
• Purchase an additi onal hose secti on, a swivel and two hose att ach clamps from your retailer.
• Cut the new secti on if necessary, see "2.6.1 If the hose is too long = Cut the feed hose".
: simultaneously unscrew and pull.
, by removing the same amount from each of these two secti ons,
0.25 cm
(for exemple)
Recommended
Feed hose (secti on 2)
0.25 cm
and
.
.
Lead hose
connecti on
Feed hose (secti on 2)
Sucti on
port
connecti on
"2.3 I Adjusti ng
See picture .
.
.
Feed hose (secti on 1)
Sucti on port
connecti on
EN
10