Inbound Filter - D-Link DWR-921 User Manual

Section 4 - Configuration
Inbound Filter enables you to control what packets are allowed to come in to your network from the Internet. The inbound filter only applies to
packets that are destined for Virtual Servers or DMZ hosts.
Select this box to Enable the filter.

Inbound Filter:

Select a schedule to use and copy to the specified rule ID when
Use Schedule
you click the Copy to button. You may select Always On or use
Rule:
a specific schedule that you have defined. To create and edit
schedules, please refer to Schedules on page 57.
INBOUND FILTER RULES LIST
Here, you can select whether to Allow or Deny all incoming traffic
except for traffic that matches the listed rules.
This identifies the rule.
ID:
Specify the local IP address and then specify the port after the
Source IP : Ports:
colon.
Specify the remote IP address and then the port after the colon.
Destination IP :
Ports:
Check the box to enable the specified rule.
Enable:
Specify the schedule rule number. Click on the Add New Rule
Schedule Rule #:
button to create a new schedule rule.
Go back to the previous filter page.
Previous Page:
Advance to the next filter page.
Next Page:
Click Apply to save your settings, or Refresh to revert to your
previous settings.
D-Link DWR-921 User Manual
Inbound Filter
45