AEG RTB91431AW User Manual page 15

Problem
Water flows inside the refrig‐
erator.
Water flows on the floor.
The temperature in the appli‐
ance is too low/too high.
If the advice does not lead to
the desired result, call the
nearest Authorized Service
Centre.
8.2 Replacing the lamp
The appliance is equipped
with a long-life LED interior
light.
It is strongly recommended
to use original spare parts
only.
Possible cause
Door was not closed com‐
pletely.
Stored food was not wrap‐
ped.
Food products prevent the
water from flowing into the
water collector.
The water outlet is clogged.
The melting water outlet is
not connected to the evapo‐
rative tray above the com‐
pressor.
The temperature is not set
correctly.
The door is not closed cor‐
rectly.
The food products' tempera‐
ture is too high.
Many food products are stor‐
ed at the same time.
The thickness of the frost is
greater than 4-5 mm.
The door has been opened
often.
1. Using a screwdriver, remove the
screw from the lamp cover.
2. Detach the lamp cover in the
direction of the arrows.
Solution
Make sure the door is closed
completely.
Wrap food in suitable pack‐
aging before storing it in the
appliance.
Make sure that food prod‐
ucts do not touch the rear
plate.
Clean the water outlet.
Attach the melting water out‐
let to the evaporative tray.
Set a higher/lower tempera‐
ture.
Refer to "Closing the door"
section.
Let the food products tem‐
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Defrost the appliance.
Open the door only if neces‐
sary.
Use LED bulbs (E14 base)
only. The maximum power is
shown on the lamp unit.
CAUTION!
Disconnect the plug from the
mains socket.
ENGLISH 15