Unpacking - KNOVA KN CM-15W3 Manual

WARNINGS
20. Keep visitors a safe distance from the work area
Keep children away.
21. Make your workshop child proof with padlocks, master
switches or by removing starter keys.
22. Give your work undivided attention. Looking around,
carrying on a conversation and "horse-play" are careless
acts that can result in serious injury.
23. Maintain a balanced stance at all times so that you do not
fall or lean against the knives or other moving parts. Do
not overreach or use excessive force to perform any
machine operation.
24. Use the right tool at the correct speed and feed rate. Do
not force a tool or attachment to do a job for which it was
not designed. The right tool will do the job better and
safer.
25. Use recommended accessories; improper accessories
may be hazardous.
26. Maintain tools with care. Keep knives sharp and clean for
the best and safest performance. Follow instructions for
lubricating and changing accessories.
27. Make sure the workpiece is securely attached or clamped
to the table. Never use your hand to hold the work piece.

UNPACKING

Open shipping container and check for shipping damage.
Report any damage immediately to your distributor and
shipping agent. Do not discard any shipping material until the
Planer is assembled and running properly.
Compare the contents of your container with the following
parts list to make sure all parts are intact. Missing parts, if
any, should be reported to your distributor. Read the
instruction manual thoroughly for assembly, maintenance and
safety instructions.
Contents of the Shipping Container
1 Planer
1 Dust Hood
2 Extension
Tables
1 Handwheel
1 Handle
2 Magnet Tools
4 Hex Wrenches
(3,4,5 and 6mm)
1 T-handle Hex
Wrench (4mm)
3 Open-end
Wrenches
(8-10, 12-14,
14-17)
3 Bags of
Fasteners
see below
1 Owner's Manual
Figure 1
Handwheel
T-handle
wrench
Handle
Hex
Open-end-
wrenches
wrenches
Fasteners
28. Turn off the machine and disconnect from power before
cleaning. Use a brush or compressed air to remove chips
or debris — do not use your hands.
29. Do not stand on the machine. Serious injury could occur if
the machine tips over.
30. Never leave the machine running unattended. Turn the
power off and do not leave the machine until it comes to
a complete stop.
31. Remove loose items and unnecessary work pieces from
the area before starting the machine.
Familiarize yourself with the following safety notices used
in this manual:
CAUTION
WARNING
SAVE THESE INSTRUCTIONS
Contents of fastener bags (Figure 2):
A – (for installing
Handwheel)
1 Direction
Label
1 Hex Nut
1 Flat
Washer
1 Key
Dust
hood
Magnet
tools
2
This means that if precautions are not
heeded, it may result in minor injury
and/or possible machine damage.
This means that if precautions are not
heeded, it may result in serious injury
or possibly even death.
B – (for installing
C – (for installing
Extension
Tables)
6 Hex Cap
Screws,
M8x25
6 Socket
Set Screws,
M8x20
Dust Hood)
6 Hex Washer
Head Screws,
M6x12
Figure 2