Nevir NVR-4901 6K1000 Manual page 23

Installation
Installation place requirement

A concrete floor is the most suitable installation surface for a washing
machine, being far less prone to vibration during the spin cycle than
wooden floorboards or a carpeted surface.

The machine must be level and securely positioned. The distance
between the machine and wall must be more than 10 cm.

To avoid vibrations during spinning, the machine should not be installed
on soft floor coverings.
Level adjustment
The machine must stand perfectly level on all four feet to ensure safe and proper operation. Incorrect
installation may increase electricity and water consumption and may cause the machine to move about.
To do these when the machine is not level: Using the
spanner turn locknut in a clockwise direction. Then turn
locknuts together with adjust feet to unscrew.
Use a spirit level to check the machine is standing level.
Hold adjust feet securely with a pipe wrench. Turn locknut
again using the spanner until it sits firmly up against the
housing
Vibration and noise may occur if the locknuts do not sit firmly up against the
Note
Drain hose connection
1. Direct into a sink
If the outlet spigot has not been used before, remove any blanking plug that may be in place.
Push the drain hose onto the spigot and secure with a clip if required, ensure a loop is formed in the
drain hose to prevent waste from the sink entering the washing machine.
If required, the drain hose can be extended to a length of 4 m.
houses
Use Process
23