Panasonic DMC-TZ80EB Service Manual page 21

Attribute Main item Sub item
Adj.History OIS
HARD FLASH Flash
FLASH Data Area
ROM
Program
Area
SOFT CPU Reset
Recording Memory
Media card
Operation Power on
Zoom Zoom
Recording Motion
Image
Recording
Wi-Fi
Important notice about "Error Code List"
1) About "*" indication:
The third digit from the left is different as follows.
+.In case of 0 (example: 18 0 01000)
When the third digit from the left shows "0", this error occurred under the condition of INITIAL SETTINGS has been completed.
It means that this error is occurred basically at user side.
+.In case of 8 (example: 18 8 01000)
When the third digit from the left shows "8", this error occurred under the condition of INITIAL SETTINGS has been released.
(Example; Factory assembling-line before unit shipment, Service mode etc.)
It means that this error is occurred at service side.
2) About "?" indication: ("18*0 0?01" to "18*0 0?50"):
The third digit from the right shows one of the hexadecimal ("0" to "F") character.
4. How to exit from Error Code display mode:
Simply, turn the power off. (Since Error code display mode is executed under the condition of temporary cancellation of "INITIAL
SETTINGS", it wake up with normal condition when turn off the power.)
Note:
The error code can not be initialized.
Error code
High Low
4 bits 4 bits
1D*0 2000 OIS adj. Yaw direction amplitude error (small)
3000 OIS adj. Pitch direction amplitude error (small)
4000 OIS adj. Yaw direction amplitude error (large)
5000 OIS adj. Pitch direction amplitude error (large)
8000 OIS adj. Yaw direction off set error
9000 OIS adj. Pitch direction off set error
A000 OIS adj. Yaw direction gain error
B000 OIS adj. Pitch direction gain error
C000 OIS adj. Yaw direction position sensor error
D000 OIS adj. Pitch direction position sensor error
E000 OIS adj. other error
28*0 0000 Flash charging capacitor did not been fully charged within
20 seconds
2B*0 0001 IC6003 (Flash-ROM) data reading error is detected when
the unit turns ON
0002 IC6003 (Flash-ROM) data writing error is detected when
the unit turns OFF
0005 Firmware update error of IC9101
0006 Firmware update error of IC1502
30*0 0001 System error (NMI reset)
|
0007
31*0 0002 Memory card physical error
During formatting the memory card, there is no response
from the memory card
If the mini-SD memory card is used, check the SD memory
card adaptor
0004 Memory card writing error
Check the memory card. It might be damage one.
3B*0 0000 Flash ROM processing early period of camera during
movement.
3C*0 0000 Imperfect zoom lens processing
Zoom lens
3F*0 0001 File time out error in recording motion image
0002 File data cue send error in recording motion image
3211 **02 Wi-Fi related errors:
| *Generally, above are unable to specified the, which cannot be used for malfunction
**0C diagnosis.
Contents (Upper)
Check point (Lower)
21
Error Indication
Detecting Part/Circuit
device
OIS ADJ OIS ADJ
STRB CHG TOP P.C.B./
FPC
FROM RE FROM
FROM WR FROM
(No indication) (No indication)
NMI RST MAIN P.C.B.
SD CARD SD CARD/
DSP
SD WRITE
INIT (No indication)
ZOOM ZOOMm/
LENSu
(No indication) (No indication)