Hunter G800 Series Owner's Manual page 16

UPPER SNAP-RING INSTALLATION I TABLE OF CONTENTS
UPPER SNAP-RING INSTALLATION – G800 SERIES
Hold the snap-ring in front of you with the wiper seal facing up and the snap-ring open ends at the
top. The snap-ring end on the left must be installed first (FIGURE 65). Lay the snap-ring on top of
the rotor and use the left thumb to force the left open end of the snap-ring into the upper snap-
ring groove within the body (FIGURE 66). Once engaged, the remaining portion of the snap-ring
can be installed by pressing in a counter-clockwise motion around the snap-ring (FIGURE 67).
FIGURE 65 FIGURE 66
Fig 65
Fig 65 Fig 65
UPPER SNAP-RING INSTALLATION – G900 SERIES
Hold the snap-ring in front of you with the wiper seal facing up and the snap-ring open ends at
the top. The snap-ring end on the left must be installed first. Lay the snap-ring on top of the rotor
and use the left thumb to force the left open end of the snap-ring into the upper snap-ring groove
within the body (FIGURE 66). Once engaged, the remaining portion of the snap-ring can be
installed by pressing in a counter-clockwise motion around the snap-ring.
Prior to installing the rubberized logo cap, the riser assembly must be pulled up above the upper
snap-ring's rubberized seal. If this procedure is not followed, the rubberized logo cap's stainless
steel screw cannot reach the riser assembly below and attachment will be impossible.
To pull the riser assembly above the upper snap-ring's wiper seal, first locate the lift-up socket
on top of the riser assembly. Using the T-Handle Tool or Snap-ring Tool or Hunter Wrench, insert
the tool into the lift-up socket, turn ¼ turn (FIGURE 67). Next, lift the riser assembly up until the
nozzles can been seen above the upper snap-ring assembly (FIGURE 68). Slowly release the riser
assembly downward until the riser assembly rests on top of the upper snap-ring assembly
(FIGURE 69).
29
FIGURE 67
Fig 66
Fig 66 Fig 66 Fig 65
Fig 65 Fig 65
As the rubberized logo cap is installed, note
there is a protruding pin on the underside of the
rubberized logo cap (FIGURE 70). This pin is the
alignment feature on the rubberized logo cap
that must be oriented and inserted into the
riser assembly correctly. Proper alignment and
installation of the protruding pin allows the
nozzle direction arrows on the rubberized logo
Fig 66
Fig 66
FIGURE 66
Fig 66
Fig 66
FIGURE 69
Fig 69
Fig 69
Fig 69 Fig 69
Learn more. Visit hunterindustries.com/golf
TABLE OF CONTENTS I
cap to be positioned over the nozzles below.
Note which hole the pin fits into (FIGURE 71).
Also note that the pin and hole locations are
different for the G90 and G95 rotors.
Install the rubberized logo cap using a Phillips
screwdriver. Tighten the stainless screw
clockwise until the screw is hand tight. Do not
over-tighten.
Fig 67
Fig 67
Fig 66 Fig 67
FIGURE 67 FIGURE 68
Fig 66 Fig 67
Fig 67
Fig 67
FIGURE 70 FIGURE 71
Fig 70
Fig 70
Fig 70
Fig 69
Fig 70
Fig 69 Fig 70 Fig 70
UPPER SNAP-RING INSTALLATION
Fig 68
Fig 68
Fig 68
Fig 68
Fig 68
Fig 68
Fig 71
Fig 71
Fig 71
Fig 71
Fig 71 Fig 71
30