User Maintenance Mode - Ricoh BL-P1 Series Service Training

After entering User Mode, press the Go button from 1 to 8 times to select
a maintenance function or mode as shown by the following table.
Refer to the FSM for details about the individual functions or modes.
Press Go Button
Once
Twice
Three times
Four times
Five times
Six times
Seven times
Eight times
Nine (or more) times
*All LEDs should light for one second.
No additional notes.

User Maintenance Mode

1) Test Sample Page
2) Print Fonts
3) USB 2.0 FULL Serial Number Return Value Setting
4) Hex Dump Mode
5) PCB Only Mode
6) 1 Push Printing Recovery Mode*
7) Network Reset 1 (APIPA: ON)*
8) NV-RAM Factory Reset*
1) Test Sample Page (same as pressing once)
Resulting Function/Mode
21