Table of Contents
Advertisement
12
www.raider.bg
Repair of electric appliances must only be carried out by experts otherwise it may cause considerable
danger for user.
Store these instructions for future reference
2. SPECIAL SAFETY INSTRUCTIONS FOR THIS MACHINE
1. Always wear eye protection.
2. Always disconnect the tool from the power source when setting up, adjusting, or changing
accessories.
3. Do not wear gloves, necktie, or loose clothing.
4. Always clamp workpiece and brace against column to prevent rotation.
5. Use recommended speed for drill accessory and workpiece rotation.
6. Be sure drill bit or cutting tools is securely locked in the chuck.
7. Be sure chuck key is removed from the chuck before connecting to power source or turning power
ON.
8. Adjust the table or depth stop to avoid drilling into the table. Shut off the power, remove the drill bit,
and clean the table before leaving machine.
9. Do not connect tool to power source or operate until it is completely assembled and installed
according to the instructions. If any part of your drill press malfunctions or has been damaged or
broken, do not operate until the part is properly repaired or replaced.
10. Never place your fingers in a position where they could contact the drill or other cutting if the
workpiece should unexpectedly shift.
11. Never use your hand to hold the object while drilling. Always clamp the object tight on the work
table or use a drill vise to prevent accidental injury.
12. Never perform any operation by moving the head or table with respect to one another. Do not
turn the switch ON or start any operation before checking that the head and table lock handles are
clamped tight to column and head and table support collars are correctly positioned.
13. Before engaging the power switch ON, make sure the belt guard is down and the chuck is installed
properly.
14. Turn the switch OFF when leaving the drill press. Do not perform layout, assembly or set-up work
on the table while the cutting tool is rotating, switched on or connected to a power source.
15. Firmly clamp or bolt you drill press to a work bench or table.
16. Mount your drill press to either a workbench or mounting board; failure to comply could result in
possible serious injury.
3. UNPACKING
A WARNING: If any part are miss-ing do not operate the tool until the missing parts are replaced.
Failure to do so could result in possible serious personal injury.
INSTRUCTIONS WHEN UNPACKING THE TOOL:
1. Carefully remove the tool and accessories from the box.
2. Make sure that all items listed in the packing list are included.
3. Inspect the tool carefully to make sure no breakage or damage occurred during shipping.
4. Do not discard the packing material until you have carefully inspected and satisfactorily operated
the tool.
4. PACKING LIST
1. COLLECTOR SUPPORT
2. COLLECTOR BODY WITH MOTOR
3. COLLECTOR
4. BASE PLATE
5. FOUR CASTERS
6. TWO BAGS
7. PACKING
8. SCREW AND WASHERS
9. SUPPORTING RODS
5.ASSEMBLY
Fully unscrew the tube joint covers on the left side of the frame base,
Leaving them in place on the tube joint base
Advertisement
Table of Contents
