Fcc Class A, Part - Alcatel-Lucent OmniSwitch 2220 Hardware Manual

OmniSwitch 2220 Hardware Guide
• EN 61000-4-3
• EN 61000-4-4
• EN 61000-4-5
• EN 61000-4-6
• EN 61000-4-8
• EN 61000-4-11
• IEEE 802.3: Hi-Pot Test
• (2250 V DC on all Ethernet ports)
Environmental Standards
• IEC 60068-2-1
• IEC 60068-2-2
• IEC 60068-2-30
• IEC 60068-2-13
• IEC 60068-2-40
• IEC 60068-2-41
• IEC 6068-2-6
• IEC 60068-2-64
• IEC 60068-2-27
• GR-63-CORE
• MIL-STD-810F Method 516.5 IV
• MIL-STD-810F Method 516.5 C

FCC Class A, Part 15

This equipment has been tested and found to comply with the limits for Class A digital device pursuant to Part
15 of the FCC Rules.These limits are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment.This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions in this guide, may cause
interference to radio communications.Operation of this equipment in a residential area is likely to cause
interference, in which case the user will be required to correct the interference at his own expense.
The user is cautioned that changes and modifications made to the equipment without approval of the
manufacturer could void the user's authority to operate this equipment.It is suggested that the user use only
shielded and grounded cables to ensure compliance with FCC Rules.
If this equipment does cause interference to radio or television reception, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient the receiving antenna.
• Relocate the equipment with respect to the receiver.
• Move the equipment away from the receiver.
• Plug the equipment into a different outlet so that equipment and receiver are on different branch circuits.
Alcatel-Lucent Enterprise
April 2018 • 060524-10 Rev. A
Regulatory Compliance and Safety Information
OmniSwitch 2220 Hardware Guide
Page 16