Silvercrest EDS-SSM 600 B2 Operating Instructions Manual page 33

Safety instructions
RISK OF ELECTRIC SHOCK
► Connect this appliance only to correctly installed mains power sockets
supplying a power voltage of 220 - 240 V ~ / 50 Hz.
► In the event of operating malfunctions and before cleaning the appliance,
remove the power plug from the wall socket.
► Do not expose the appliance to humidity and do not use it outdoors.
► Should liquids enter the housing, disconnect the appliance from the mains
power socket immediately and arrange for it to be repaired by a qualifi ed
technician.
► To unplug the appliance, always pull the plug from the socket, do not pull
on the power cable itself.
► Do not crease or crimp the power cable and place it in such a way as to
prevent anyone from stepping on or tripping over it.
► To avoid unnecessary risks, arrange for defective power plugs and/or
cables to be replaced at once by qualifi ed technicians or our Customer
Service Department.
► Do not attempt to open motor unit casing of the hand blender. Should you
do so, the safety concept of the appliance may be compromised and the
warranty becomes void.
► This appliance is not intended for use by individuals (including children)
with restricted physical, physiological or intellectual abilities or defi ciences
in experience and/or knowledge unless they are supervised by a person
responsible for their safety or receive from this person instruction in how
the appliance is to be used.
► Children should be supervised to ensure that they do not play with the
appliance.
RISK OF ELECTRIC SHOCK
WARNING! RISK OF INJURY!
► Before changing accessories or additional parts that are in motion during
operation, the appliance must be switched off and disconnected from
mains power.
► Children must not be allowed to operate the appliance without adult
supervision.
► Always disconnect the appliance from mains power if it is being left un-
attended.
EDS-SSM 600 B2
Under no circumstances may the motor unit be immersed in liquids,
or liquids be permitted to permeate into the motor unit housing.
GB
MT
31