Filtering & Changing The Oil; Care And Cleaning - Platinum DF7702-GS Instruction Manual

ENGLISH
FILTERING & CHANGING THE OIL
Make sure the Deep Fryer is unplugged from the electrical socket and the oil has cooled (approximately
2 hours) before changing the oil, or cleaning and storing the Deep Fryer.
Note: The oil does not need to be changed after each use. In general, the oil will be tainted rather quickly
when frying food containing a lot of protein (such as poultry, meat or fish). When oil is mainly used to fry
potatoes and is filtered after each use, it can be used 8 to 10 times. However, do not use the same oil for
longer than 6 months.
To Filter the Oil:
1. Make sure the oil has cooled (approximately 2 hours) and then empty the oil from the oil reservoir into
another container or bottle.
2. Wash and dry the oil reservoir and frying basket.
3. Refill the oil reservoir with the oil by pouring the oil through a wire strainer or paper filter.

CARE AND CLEANING

Clean the Deep Fryer on both the inside and outside regularly.

 Clean the outside of the Deep Fryer with a damp cloth and dry with a soft, clean cloth.
 Never use abrasive cleaners or sponges.
 Clean the control panel with a damp cloth only.
 The basket and the handle can be cleaned in warm, soapy water. Dry well before using again.
 When replacing the oil you can also clean the inside of the Deep Fryer. Empty the Deep Fryer and
first clean the inside with a paper towel and then with a cloth dipped in soap water. Then wipe with a
damp cloth and allow drying thoroughly.
 All components, with the exception of the electrical parts, may be cleaned in warm soapy water. Dry
thoroughly before use.
 Dishwasher cleaning is not recommended.
THE RESET FEATURE
Your deep fryer is equipped with a reset feature. If for some reason the deep fryer stops heating, the
reason may be that the reset switch has tripped.
To reset the deep fryer:
1. Unplug the appliance from the electrical wall outlet.
2. Let the appliance and the oil in the oil reservoir cool completely.
3. After the appliance has cooled completely, lift the control panel and
using the tip of a ball point pen or pencil, push the thermostat reset
button that is located on the inside of the control panel (Fig. 1)
4. Re-assemble the control panel to the housing of the deep fryer and then
you may resume frying.
6
RESET
BUTTON
Fig. 1