Dell PowerEdge T350 Installation And Service Manual page 114

Figure 103. Installing the BOSS S2 module blank
To install the BOSS S2 module:
1. Install the BOSS S2 module . To install the BOSS S2 , see
2. Install the M.2 SSD. To install the M.2 SSD, see
NOTE: Installing the BOSS S2 card carrier does not require the system to be powered off. System shutdown is only
required when installing the BOSS S2 controller card module.
To remove the BOSS S2 controller card module:
1. Power off the system and
2. Remove the M.2 SSD. To remove the M.2 SSD, see
3. Remove the BOSS S2 module. To remove the BOSS S2 controller card module, see
to 7.
4. Install the BOSS S2 module blank.
NOTE: Removal of the BOSS S2 card carrier does not require the system to be powered off. System shutdown is only
required when removing the BOSS S2 module.
NOTE: Disconnect the BOSS signal cable and the BOSS power cable before lifting the module from the system.
114 Upgrade Kits
installing the BOSS S2 module
remove the system cover.
installing the BOSS S2 module
removing the BOSS S2 module
steps 1 to 3.
steps 4 to 8.
steps 1 to 4.
removing the BOSS S2 module steps 5