Raider RD-AC07 User Manual page 12

12 www.raider.bg
always take the plug out of the plug socket.
• Always make sure that compressed-air
hoses are used for compressed air and which
are characterised by a maximum pressure
adjusted to that of the compressor. Do not try
to repair the hose if it is damaged.
3. USE
The compressor is used as a power supply
for pneumatic machines.Only used indoors!
NB: The information you will find in
this manual has been written to assist the
operator in the use and maintenance of the
compressor. Some illustrations in this manual
show details which may differ from those of
your compressor.
Installation
After having taken the compressor out of
its packaging and having checked that it is
in perfect condition, and having noted that
no damage occurred during transport, the
following acts should be performed. If not yet
fitted, fit the rubber feet and the wheels on the
tank according to the instructions represented
in. Place the compressor on a flat surface or
at a maximum slope of 10°, in a well ventilated
area, protected against atmospheric factors
and not in explosive surroundings. If the
surface area is sloping and smooth, make
sure that the compressor will not move when
in operation. If the surface area is a board or a
shelf of a bookcase, just make sure that they
cannot fall down by securing them properly.
For proper ventilation and effective cooling, it
is important that the compressor is positioned
at least 100 cm from the wall.
Make sure that the compressor is transported
in the right way, do not turn it upside down
and don't lift it with hooks or ropes
STARTING UP
• Check whether
corresponds to that indicated on the electrical
specification plate, the permitted tolerance
range should be within 5%.
• Press the switch situated on the upper part
into the "0" position according to the pressure
regulator type fitted on the device.
• Put the plug in the plug socket and start
the compressor up by putting the switch of
the pressure regulator in the "I" position.
The operation of the compressor is fully
automatic.
The pressure regulator
the mains voltage
will stop
compressor
has been reached and start it up when the
pressure drops below the minimum value.
Normally the difference in pressure is
approx. 2 Bar/29 psi between the maximum
and the minimum value. For instance - The
compressor will stop when it reaches 8 Bar
(116 psi) (this is the maximum operating
pressure) and will start up automatically when
the pressure within the tank has dropped to
6Bar (87 psi).
The head/cylinder/transmission
assembly may reach high temperatures, so
take care when working close to these parts
and do not touch them to avoid
burns.
ADJUSTING THE OPERATING PRESSURE
It is not necessary continuously to use
the maximum
compressed-air tools often require less
pressure. With
supplied with a pressure reduction valve it
is necessary to set the operating pressure
properly.
It is possible to set the operating pressure by
using the turning knob on the reduction valve.
• By turning clockwise, the pressure will be
increased.
• By turning anti-clockwise, the pressure will
be reduced.
The compressor has pressure gauge and two
points to connect an air hose:
The set pressure is visible on the manometer
of the reduction valve.
4. MAINTENANCE
Make sure that the plug is removed from the
mains when carrying out maintenance work
on the motor.
The machines have been designed to operate
over a long period of time with a minimum
of maintenance. Continuous satisfactory
operation depends upon proper machine care
and regular cleaning. Before interfering in any
way whatsoever with the compressor, please
make sure that:
• The general line switch is in the "0" position.
• The pressure regulator and the switches on
the switch board are switched off in the "0"
position.
the • The air tank is fully decompressed.
when the maximum
operating pressure,
regard to compressors
value
pipe
the