Cisco Business 350 Series Manual page 8

Configure stack settings through the command line interface (cli)

Hide thumbs Also See for Business 350 Series:

copy running-config startup-config

CBS350-2#

Step 9 (Optional)

Press Y for Yes or N for No on your keyboard once the Overwrite file [startup-config]... prompt

appears.

Step 10

Reload the switch to apply the configured stack settings by entering the following:

reload

CBS350-2#

Important: When a switch is reloaded, the running configuration file is deleted. Before proceeding

with the reload instructions, make sure to save all the running configuration settings to avoid data

loss.

Step 11

Press Y for Yes or N for No on your keyboard once the Do you want to continue prompt appears.

After the switch reboots, the Standby switch will no longer be a standalone device and will only be

accessible through the active switch.

Step 12

Repeat steps 1 to 11 for the configuration of the member switch or switches.

You should now have configured the stack settings on your Standby and/or member switches.

Show Stack Configuration Settings on the Switch

Step 1

Log back in to the console of the Active unit.

Quick Tip: Access the Active unit while configuring the Standby and/or Member switches to

monitor the progress. Once the Standby or Member switch reboots, the active switch will be

notified with the stacking activities.