Jasco Energizer Quick Start Manual

Remote Controlled
LED Light Bars
BATTERY INSTALLATION
1. Slide o narrow battery compartment
cover.
2. Insert batteries, noting polarity.
Remote: To replace exhausted battery, slide the battery
holder out, following the drawing on the bottom of the
remote. Insert 1 fresh CR2025 battery, noting polarity.
Replace the battery holder.
Important: Di erent types of batteries, or new and used
batteries, should not be mixed. Exhausted batteries should
be removed from the xture and disposed of properly.
Surface Mounting
1. Clean the mounting surface of any dust or debris.
2. Peel the paper backing from the metal strip and press
READ IT OR WATCH IT
3. Place the magnetized back of
Note: You can mount the light to other magnetic surfaces
without using the metal strip.
Read instructions or watch
easy-to-follow video.
Scan QR code or visit
http://byjasco.com/47737i
MADE IN CHINA/HECHO EN CHINA
©2021 Energizer. Energizer and certain
graphic designs are trademarks of
Energizer Brands, LLC and related
subsidiaries and are used under license by
Jasco Products Company, LLC.
Contact our U.S.-based Consumer Care at
1-800-654-8483 between 7AM–8PM,M–F,
Central Time.
90-day warranty. Visit www.byjasco.com
for warranty details.
it rmly onto the surface
the light bar onto the mounted
metal strip.
REMOTE OPERATION:
1. On the remote, press the ON button to
turn the lights on, or press the OFF
button to turn them o .
2. Use the + and - buttons to brighten or
dim the lights.
3. The 10%, 40%, 80% and 100% buttons
allow you to go directly to your desired
output level
4. The 10min, 30min, 1hr and 2hr buttons
automatically turn the lights o after
the number of minutes indicated on
the button.
Note: When using the remote, point
directly at the puck for proper
connection.
OPERATION
ON/OFF/IR Switch; Manually turn the light
ON or OFF and activate the light bar's
connection with the IR remote.
47737_48635 Manual v1
12/18/2020