Table of Contents
Advertisement
Quick Links
Induced Combustion Gas Furnace
NOTE TO INSTALLER:
THIS MANUAL MUST BE LEFT WITH
THE EQUIPMENT USER.
USER
: Please read all instructions in the manual and retain
all manuals for future reference.
ISO 9001:2000
REGISTERED
Use of the AHRI Certified TM Mark indicates a
manufacturer's participation in the program. For
verification of certification for individual products,
go to www.ahridirectory.org.
Owner's Manual
A10252
Always Ask For
WARNING
!
FIRE OR EXPLOSION HAZARD
Failure to follow safety warnings could result in injury, death,
or property damage.
Do not store or use gasoline or other flammable vapors and
liquids in the vicinity of this or any other appliance.
WHAT TO DO IF YOU SMELL GAS
- -Do not try to light any appliance.
- -Do not touch any electrical switch; do not use any
phone in your building.
- -Leave the building immediately.
- -Immediately call your gas supplier from a near by phone.
Follow the gas supplier's instructions.
- -If you cannot reach your gas supplier, call the fire
department.
Installation and service must be performed by a qualified
installer, service agency or the gas supplier.
WARNING
!
CARBON MONOXIDE POISONING HAZARD
Failure to follow this warning could result in personal
injury and/or death.
Carbon Monoxide is invisible, odorless, and toxic! Bryant
Heating and Cooling Systems recommends a carbon
monoxide alarm in your home, even if you do not own a
gas appliance. Locate the carbon monoxide alarm in the
living area of your home and away from gas appliances and
doorways
to
attached
manufacturer's instruction included with the alarm.
WARNING
!
ELECTRICAL OPERATION HAZARD
Failure to follow this warning could result in personal injury,
death, or property damage.
Do not use this furnace if any part has been under water. A
flood- -damaged furnace is extremely dangerous. Attempts to
use the furnace can result in fire or explosion. A qualified
service agency should be contacted to inspect the furnace and
to replace all gas controls, control system parts, electrical parts
that have been wet or the furnace if deemed necessary.
1
garages.
Follow
the
alarm
Advertisement
Table of Contents
Related Manuals for Bryant A10252
Summary of Contents for Bryant A10252
- Page 1 CARBON MONOXIDE POISONING HAZARD Failure to follow this warning could result in personal injury and/or death. Carbon Monoxide is invisible, odorless, and toxic! Bryant Heating and Cooling Systems recommends a carbon monoxide alarm in your home, even if you do not own a gas appliance.
- Page 2 STARTING (LIGHTING) AND SHUTTING DOWN THE FURNACE WARNING ......4,5 PROPER FURNACE SHUTDOWN PROCEDURES .
-
Page 3: Before Starting Your Furnace
S DO NOT: In any way block or restrict airflow to your supply air and return air grills. S DO NOT: Use your furnace room as a broom closet or a place to store any kind of chemical or cleaner. -
Page 4: Steps For Starting Your Furnace
Your furnace uses an automatic, hot surface ignition system to light the burners each time the thermostat signals the furnace to start. Follow these important safeguards: Never attempt to manually light the burners with a match or other source of flame. -
Page 5: Shutting Down Your Furnace
5. Turn the switch on the gas control to the OFF position. (See Fig. 7.) A06189 6. Replace the outer furnace door. (See Fig. 9.) 7. If the furnace is being shut down because of a malfunction, call your dealer as soon as possible. -
Page 6: Filtering Out Trouble
Replace disposable media filter at least twice a year. If your furnace filter needs replacing, be sure to use the same size and type of filter that was originally specified. The air filter for the furnace may be located in a filter cabinet attached to the side or bottom of the furnace. - Page 7 Fig. 16 - - Slide Side Filter Out of Furnace Fig. 17 - - Slide Bottom Filter Out of Furnace 4. Inspect the filter. If torn, replace it. NOTE: If a washable filter has been replaced with: a. Factory specified disposable media filter — Do not clean.
- Page 8 If the switch trips a second time, turn off the furnace and call for service. S If your furnace still fails to operate, call your servicing dealer for troubleshooting and repairs. Tell your dealer the model and serial numbers for your furnace.
-
Page 9: Maintenance Checklist
Clean as needed. This list may not include all maintenance items, and inspection interval times may vary depending on operational conditions of the furnace. Ask your servicing dealer for further details about an economical service contract that covers seasonal inspections. - Page 10 Have available the Model No., Series Letter, & Serial No. of your equipment to ensure correct replacement part. Copyright 2010 Bryant Heating & Cooling Systems, 7310 W. Morris St. Indianapolis, IN 46231 Manufacturer reserves the right to change, at any time, specifications and designs without notice and without obligations.