Challenge Xtreme BMS210MS.1 Original Instructions Manual page 15

g
Fig. N1
Fig. N2
The 45° bevel tilt should also be adjusted
use a 45° set square or miter gauge (g, not
supplied), to check the 45° angle, adjust the
set screw (j) for 45° to set the correct stop
position. (See O1, O2)
Fig. O1
Fig. O2
OrIgINaL INstructIONs
2. cHaNgINg tHE saw bLadE
(see P1-P4)
Disconnect the saw from the power supply.
Lower the saw head until the blade securing
i
bolt can be seen.
Press the blade spindle lock (k) and rotate
the blade until it is locked, then loosen and
remove the blade securing bolt, the outer
flange with the socket wrench in clockwise
direction.
NOtE: Blade securing bolt has a left hand
thread.
Remove the blade, (we recommend the
use of a stout glove for this). Clean any
saw dust and debris from the arbor and saw
blade securing flanges.
To refit the blade, follow the above
HELPLINE NO 08448012949
Fig. P1
Fig. P2
Fig. P3
15