Viking K-1900-7 Series Product Manual page 5
Hot-line panel phone
Hide thumbs
Also See for K-1900-7 Series:
- Technical practice (4 pages) ,
- Application note (2 pages) ,
- Application note (1 page)
Table of Contents
Advertisement
D. Programming Feature Quick Reference
Description
Speed dial number
Q (anywhere in the speed dial number)
# (anywhere in the speed dial number)
Set dialing speed to normal (Touch Tones: 120ms on/off, Pulse: 10 pps) (factory setting)
Set dialing speed to fast (Touch Tones: 50ms on/off, Pulse: 20 pps)
Block hand held pocket dialers (factory setting)
Allow hand held pocket dialers
Normal pre-dial pause (approximately 1.4 sec) (factory setting)
Short pre-dial pause (approximately 800 ms)
To add a one second pause at any point in the dialing string
To add a four second pause at any point in the dialing string
Toggle between Pulse and Touch Tone dialing (see section I)
Set default volume 1-4 (1 = min, 4 = max) and control (1 = enabled, 2 = disabled) (factory 1,1)
Change security code (factory set to 845464)
To clear the speed dial number and return all programming to factory settings
Note: Special features such as Q, #, a mode change and a pause, use single digits in the programming memory.
E. Dialing Speed
To set the dialing speed, access the Programming mode as shown in section B, then choose a speed. To set the
dialing speed to Normal (Touch Tone: 120ms on/off, Pulse: 10pps), enter Q1. To set the dialing speed to Fast (Touch
Tone: 60ms on/off, Pulse: 20pps), enter Q2.
F. Hand Held Pocket Dialers
G. Pre-Dial Pause
In the single number auto-dialer mode, the time from when the handset is taken off-hook until the K-1900-7 auto-dials
can be programmed. Access the Programming mode (section B), then choose a pause length. To set the pause length
to Normal (approximately 1.4 seconds), enter Q5. To set the pause length to Short (approximately 800ms) enter Q6.
H. Pauses in the Dialing String
To set pauses in the dialing string, access the Programming mode as shown in section B, then enter Q7 to put a 4
second pause anywhere in the dialing string, or #7 for a 1 second pause.
Enter Digits
1-32 digits (0-9)
QQ
Q#
Q1
Q2
Q3
Q4
Q5
Q6
#7
Q7
Q8
2 digits (1-4, 1-2)
6 digits (0-9)
###
5
+
Memory Location
then
#00
then
#46
then
#47
Advertisement
Table of Contents
